Polaris General 2 Seat Rock Sliders by Side by Customs

Our rock sliders are built with 1/8" steel. They are built to function but also to compliment your machine. These sliders are attached with our custom made brackets and 5/16" bolts.

Sliders are bent and wrap under the machine 2"

Comes with all mounting hardware.

Comes in pairs of left and right.

Standard pricing is regular; texture black; and square tubing.

Pricing changes with color; round tubing; and XP version options.

Instructions

• Remove T-40 Torx screws from side of machine that is threaded into the frame. 2 seat cars will have 3 per side; 4 seat cars will have 4 per side.
• Drill out threaded holes IN THE FRAME of the machine; that the torx screws came out of; with a 1/4" drill bit. (Do not drill out the bracket)
• Frame needs to be drilled out so the bracket gets sucked up tight inside the frame.
• Use the supplied 5/16" bolt; threaded into supplied bracket; and fish that into the frame towards the newly reamed out hole.
• TIP- Do not completely clean out threads of thread cut filings. It helps keep the bracket horizontal to slide into the frame.
• Screw the T-40 Torx screw back into its original (drilled out) hole; and tighten it into the bracket that is now inside the frame. There are enough washers to add a washer to the T-40 Torx screw. It is not uncommon for the plastic to be pulled through on these older Polaris machines.
• Once you have the Torx screw threaded into the bracket; use the supplied bolt (still threaded into the bracket) and center the bolt in the hole in the frame; and tighten up. Do not over tighten; as you may strip threads; or break the bolt.
• Unthread the 5/16" bolt; and repeat. Once all brackets are installed on one side; you can install the slider.
• As you are installing; a small screwdriver may help in aligning the brackets to the mounts on the sliders.